VE24V/30A DG SETS BATTERY CHARGER
Product details
Battery charger for charging Lead Acid battery for Engine-start applications:
- Input Range 170V to 270V operating range
- Operating Temperature -20 to 85 Deg C
- Low Standby Power Consumption and High Efficiency
- High Input Output isolation 3000V AC and High surge immunity
- Input over and under voltage protections
- Output short circuit, over-load, over-voltage protection
- Charges battery from zero volts
- Draws zero current from the battery
| Input Specifications: | |
| Input Voltage | 170V - 270V AC |
| Input Voltage Frequency | 40Hz to 65Hz |
| Input Current | 1A Typical at 230V AC |
| Input Inrush Current | Limited by NTC Thermistor to 35A |
| Leakage current | <2 mA at 230V AC |
| Output Specifications: | |
| Output voltage: | Float Mode: 26.2V to 26.5V DC; Boost Mode: 27.8V to 28.4V DC |
| Charging current in boost mode | 30 amps |
| Charging current in float mode | 0 amps to 6 amps |
| Line Regulation | <1% |
| Load Regulation | <1% |
| Ripple and noise | 150 mv p-p |
| Stand-by Power Consumption | 3W |
| Protections: | |
| Input under voltage | Cutoff level 140V AC; Turn on voltage 160V AC |
| Input over voltage | 320V AC units shuts off if voltage goes above this value and automatic restart when input is less than 275V AC |
| Output over voltage (Battery charger included) | 30V DC |
| Output short circuit and overload | Continuously Protected |
| Battery reverse polarity | Protected |
| Current drawn by charger from battery | Draws zero current from the battery under any circumstances |
| Externally Induced Over voltage | Protected against output over-voltage caused by parallel connection of alternator, etc. |
| Annunciation | Potential free NO/NC contact for charger ON/Fail indication |
Similar products
